If you can't measure the holes accurate, there are measurements in the Bentley for their placement. Jim On Sun, Jun 15, 2008 at 11:03 AM, Paul Guzyk <paullist08@guzyk.com> wrote: > Very easy. Use a 1/4 drive 10mm deep socket and extension. > > Loosen (no need to remove) the nuts from behind the panels looking > straight up while you lie on your back. When all nuts are loose the > panels pull off from the bottom. > > Once the panels are off you can remove the panel mounts. The mounts > are pop-riveted onto the body so you will have to use a drill and > drill out the rivets. > > If you intend to mount the mounts onto another van, measure / take > photos of where the holes are. > > > > > How does the fiberglass side skirting come off of the newer Vans? our 91 >> became a "organ donor" yesterday and we are stripping here for other uses >> >> -- >> 1985 Full Westy "Rustfalia" >> 1982 Full Westy "dead engine" >> 1991 GL >> 1972 Honda Z600 2 cyl >> > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.