Neat! And speaking of table mods...... In converting my Westy to a Jetta engine, I figured it would be nice to have a laptop table (to run OBD software) at rear of rear cabinet. (the OBD plug is near there) It looks like a 1/2" or thicker piece of plywood could fit. Just bolt on a hinge and some kind of leg. It looks like one could have two tables on the end of the cabinet! (overkill though) And although likely not nessecary, one could also cut an access hole at rear of cabinetry. The table would flip up to cover the hole. Neil. On Sun, Jun 29, 2008 at 6:41 PM, Edward Maglott <emaglott@buncombe.main.nc.us> wrote: > Check out these things I found on flickr: > > http://www.flickr.com/photos/themeganandguymichael/2620959973/ > > http://www.flickr.com/photos/themeganandguymichael/2621772232/ > > http://www.flickr.com/photos/themeganandguymichael/2621778366/ > > Looks like some good ideas I hadn't seen before. This photostream > has a lot of interesting vanagon pictures. > > Edward >
-- Neil Nicholson '81 JettaWesty "Jaco http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines http://web.mac.com/tubaneil http://tubaneil.googlepages.com/ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.