Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2008, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 1 Jul 2008 22:45:56 -0700
Reply-To:     Mike Miller <mwmiller@CWNET.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike Miller <mwmiller@CWNET.COM>
Subject:      Re: Turbo overpressure
Comments: To: mailinglist@fastforward.ca
In-Reply-To:  <1964.192.168.0.115.1214977576.squirrel@hasenwerk.homeip.net>
Content-Type: text/plain; charset="US-ASCII"

Cool, thanks. Now to find out how much overpressure it delivers and what altitude it can deliver sea level pressure boost at.

Hmm.

Mike

On 7/1/08 10:46 PM, "David Marshall" <mailinglist@fastforward.ca> wrote:

> The AAZ is a simple waste gate control - a simple spring that opens at X > pressure. In effect it should behave the same way as the computer controlled > one does as it doesn't compare the ambient pressure with the manifold > pressure. > > David Marshall > > http://www.hasenwerk.ca > Box 4153, Quesnel BC, Canada V2J 3J2 > > Engine Conversion FAQ - http://www.hasenwerk.ca/faq > > On Tue, July 1, 2008 22:16, Mike Miller wrote: >> > >> > Thanks for the technical part of how it does what it does. >> > >> > I realized what it did in effect but what I asked was does the AAZ turbo >> > work this way and if it does to what altitude can it feed the engine the >> > full boost the engine expects? >> > >> > Mike >> > >> > On 7/1/08 7:10 PM, "David Marshall" <mailinglist@FASTFORWARD.CA> wrote: >> > >>> >> It's all relative... >>> >> >>> >> The TDI and most other modern turbo >>> >> engines uses a MAP or Manifold Absolute Pressure sensor. So, in an >>> >> absolute vacuum the ECU will see 0 mbar - at sea level on an average day >>> >> you will see 1000mbar and at the top of a mountain it will be say >>> >> 900mbar >>> >> - these values are all with the engine off. So the ECU controls >>> >> boost using this MAP sensor - for a stock ALH TDI this is 1950mbar for >>> >> maximum boost, which if you compare it to the outside air pressure, it >>> >> will be higher in a mountain than at sea level, but in effect, it is the >>> >> same amount of pressure on the inside of the manifold. >>> >> >>> >> David >>> >> Marshall >>> >> >>> >> http://www.hasenwerk.ca >>> >> Box 4153, Quesnel BC, >>> >> Canada V2J 3J2 >>> >> >>> >> Engine Conversion FAQ - >>> >> http://www.hasenwerk.ca/faq >>> >> >>> >> On Tue, July 1, 2008 16:04, Mike >>> >> Miller wrote: >>>> >>> >>>> >>> All, >>>> >>> >>>> >>> When I had an >>> >> 02 TDI I was told the turbo produced more boost than the >>>> >>> engine >>> >> was set up for at sea level. This allowed full power to 5000 feet >>>> >>> where the boost no longer had to bled off. >>>> >>> >>>> >>> >>> >> Also told the 944 turbo Porsche was set up the same way. >>>> >>> >>>> >>> Anyone know is this is true and if it's true for the TD engines? >>>> >>> >>>> >>> Mike >>>> >>> >> >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.