At 03:09 PM 7/15/2008, joel walker wrote: > 1. Ground Cluster - under dash, left/driver side, > above fuse box. > push-on connectors become corroded/dirty > and fail to make consistent electrical contact. ALL wiring that carries significant current: deterioration of wire-to-terminal crimp, evidenced by melted insulation at crimp. Same can be caused by poor connection of push-on terminal, but less common in my experience (the ground terminals are a special case because they're plugged onto steel tabs when they're meant for brass).
> 2. Fan Resistor - Radiator Fan Only on later, single-speed fan motors.
> 3. Fan Resistor - Rear Seat Heater Fan > > 4. Fan Resistor - Dash Heater Fan Dash heater fan switch is overloaded on high position and eventually melts. Dash heater fan circuit is overloaded on high position. Cure for both problems is to add a relay and new feed circuit for the high-speed position.
> 5. Power Windows > > 6. Power Door Locks > > 7. Ignition Switch - steering column Horn slip-ring contact on steering wheel wears through.
> 8. Headlight Switch - dash instument pod License plate lights internal parts are made of steel (thank you Hella) and corrode.
> 9. Engine ground strap - left/driver side of engine > >10. ?? 2.1 ECUs have overheat problems with ignition drive transistors. All ECUs have problems with solder fatigue. A real PIA in every way. Temp gauge flashing light fails in flashing condition due to leakage in internal capacitor aggravated by humidity-induced leakage across circuit board. Cure by disassemble gauge, replace electrolytic cap (preferably with a tantalum), clean circuit board. Requires moderately delicate soldering and drilling out faceplate rivets. New-type Westy water level sender (wand extending into tank) is designed to fail either by physically breaking internal switches if wand is flexed even slightly, or by failure of upper seal allowing water ingress -- a drop or two is enough to make it malfunction. Latter failure often evidenced by changing behavior of the lights after the panel is powered on.
>so do we want to identify the problem area and location, and then >state the likely cause of the problem, and then the/a cure? I think a hugely valuable meme to introduce into this culture would be the understanding/belief that electrical supply problems are actually quite easy to diagnose definitively; that it's generally better to do this than rely on shotgun approaches; and that a voltmeter, a length of wire and a pin are all that is needed. Basically a supply circuit is a long string that goes from battery plus to battery minus, and the entire battery voltage is distributed along that string in an orderly way. When the circuit is working correctly, almost all the voltage appears between the plus and minus terminals of the load -- headlight or whatever. But when it *doesn't* i.e. when the load isn't getting the supply it should, the place or places where the voltage *does* appear define the location(s) of the problem precisely.
>unca joel -- David Beierl - Providence RI USA -- http://pws.prserv.net/synergy/Vanagon/ '84 Westy "Dutiful Passage," '85 GL "Poor Relation" |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.