hi, not following you exactly Jim, I will always say that if both units are old, and you replace one, it's fairly likely the new strong one will blow out the older weaker one before too long. On using vaccuum to bleed - I'm sure that works. I've never liked that idea much as seems to me it could suck in air. Bleeding that way would eleminate the difficulty of getting a new clutch master cylinder to start moving fluid through that line back to the slave. The displacement of the clutch M/C is so small each stroke, that in a dry system it has trouble bleeding at first with either the two person method, or the one person 'bottle of brake fluid with clear hose' method. Once going though...... I personally like using the master cylinder, either clutch or brake, to push fluid and air through the system - you can just feel when it's working right. well are we talking about brakes or clutch system here ? one guy talks about brake bleed valve on the back of a wheel, another person about 'the slave' ............and while rear wheel cylinders 'can' be called slaves..........usually they are not. they're called 'rear wheel cylinders' and 'the slave' refers to the clutch slave cylinder.
----- Original Message ----- From: "Jim Felder" <jim.felder@GMAIL.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, July 21, 2008 10:02 AM Subject: Re: Master Cylinder - Help!
> I'm not so sure about this. It may be true, and a lot of people think it, > but it also may be--and I know that this is true--that the slave will need > bleeding a few hundred to a thousand miles after the master is replaced, > leading one to believe that the slave has failed also. > Jim > > > On Mon, Jul 21, 2008 at 8:48 AM, Jonathan A. Sinclair < > jonathan@jasinclair.com> wrote: > >> Always replace the slave and the master together - if one is worn out, >> likely the new one will wear out the other quickly. >> >> There is a bleed screw on top of the slave in the engine compartment you >> can open that and use a vacuum bleeder to do the job. Will also serve >> to clean out your line. >> >> Good luck. >> Jonathan >> >> >> John Rodgers wrote: >> >>> Sounds like you need to open the bleeder valves on the back of the wheel >>> and have someone pump the brake pedal while you bleed each brake. If >>> that doesn't do it, then you may have a bad MC. It can happen, has >>> happened, will happen. >>> >>> John Rodgers >>> 88 GL Driver >>> >>> pete wrote: >>> >>>> 80 Westy - installed a rebuilt brake MC from a list vendor - the male >>>> from the servo and the female on the MC are mated. I fill the >>>> reservoir and pump the pedal - the reservoir stays at the same level >>>> and there is no brake resistance. Any ideas? Please? >>>> >>>> TIA >>>> >>>> Pete >>>> >>>> >>>> >>>> >>> >>> |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.