Date: Wed, 16 Jul 2008 10:57:07 -0600
Reply-To: Paul Connelly <vanagonhummingbird@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Paul Connelly <vanagonhummingbird@GMAIL.COM>
Subject: Re: Can Anyone Identify This "Thing"?
In-Reply-To: <0a4301c8e711$cdbf8480$6401a8c0@PROSPERITY>
Content-Type: text/plain; charset=ISO-8859-1
Hey Scott/Richard,
Thanks again. The last pipe/tube is the one from the base of the unit
assuming the switches were on the top, and it is labeled as being "High
Flow". I couldn't trace it forward of the gearbox/fuel tank, and the other
wires/lines had been tied all down the drivers side rail running the length
of the van. It may be that its already been "cut" and just worked its way to
its present location. If it was the disengage switch (return?) line then it
may just be sitting there like the cabling was...
Paul.
On Wed, Jul 16, 2008 at 1:01 AM, Scott Daniel - Turbovans <
scottdaniel@turbovans.com> wrote:
> hmmm.........
> 'other line' ?
> if you're referring to something in the picture - that's dozens and dozens
> of emails ago and hard to find - the original post with the pic.
> if you are referring to what I just commented on ........
> there are just 3 branches to the T of course .............the one to the
> gizmo, which you'll block off or as you say, replace with a straight
> piece..........
> one engine goes to the intake plenum , and the other goes all the way
> forward.
>
> the other poster mentioning that that vaccum line may also go to clutch and
> brake switches.........good thinkin' there ! ...
> if that's the case........remove those too, and cap off as neccesary.
> scptt
>
> ----- Original Message -----
> *From:* Paul Connelly <vanagonhummingbird@gmail.com>
> *To:* Scott Daniel - Turbovans <scottdaniel@turbovans.com>
> *Cc:* vanagon@gerry.vanagon.com
> *Sent:* Tuesday, July 15, 2008 9:07 PM
> *Subject:* Re: Re: Can Anyone Identify This "Thing"?
>
> I agree Scott, any ideas on the other line?
>
> Paul
>
> On Tue, Jul 15, 2008 at 9:35 PM, Scott Daniel - Turbovans <
> scottdaniel@turbovans.com> wrote:
>
>> I suspect you are talkiing about a black plastic vacuum line , about 1./2
>> inch outside diameter.
>> one end is connected to the middle part of the intake manifold
>> system........the other end goes all the way forward to the Vaccum Brake
>> Booster above the pedals in front.
>> just cap off the T to the gizmo and you'll be done with that part, or at
>> least functional without the gizmo being there.
>> Unless I have a future planned use, I don't like things that don't have a
>> function on the engine or van.
>>
>> scott
>> ----- Original Message ----- From: "Paul Connelly" <
>> vanagonhummingbird@GMAIL.COM>
>> To: <vanagon@GERRY.VANAGON.COM>
>> Sent: Tuesday, July 15, 2008 6:56 PM
>>
>> Subject: Re: Can Anyone Identify This "Thing"?
>>
>>
>> So the hose from the intake manifold that the booster pump is teed in
>>> to is
>>> a brake vacuum line then? Any idea what the other line does or goes?
>>>
>>> Paul.
>>>
>>> On Tue, Jul 15, 2008 at 7:50 PM, Richard Golen <rgolen@hotmail.com>
>>> wrote:
>>>
>>>
>>>> The vacuum hose would probably go up in to the cab and connect with a
>>>> vacuum switch on the brake and clutch pedals. Assuming you aren't going
>>>> to
>>>> rebuild the cruise system, I'd remove all of the stuff in the engine
>>>> compartment.
>>>>
>>>>
>>>>
>>>> > Date: Tue, 15 Jul 2008 19:28:16 -0600
>>>> > From: vanagonhummingbird@GMAIL.COM
>>>> > Subject: Re: Can Anyone Identify This "Thing"?
>>>> > To: vanagon@GERRY.VANAGON.COM
>>>> >
>>>> > Thanks Bob/Richard,
>>>> >
>>>> > That would make sense - there are other traces of cruise having been
>>>> there
>>>> > at some time. So where would the pipe that runs forward between the
>>>> gearbox
>>>> > and gas tank go? and what is that line that is providing the vacuum?
>>>> > Presumably I can remove the T and replace it with a straight through
>>>> > connector on that line, but the other one I can't see or even feel >
>>>> where
>>>> it
>>>> > goes..
>>>> >
>>>> > Paul.
>>>> >
>>>> > On Tue, Jul 15, 2008 at 7:07 PM, Bob Stevens <mtbiker62@hotmail.com>
>>>> wrote:
>>>> >
>>>> > > Wondering if this is part of an aftermarket cruise control. In about
>>>> '91,
>>>> > > maybe '93 there was a recall on cruise controls and some variety of
>>>> > > aftermarket-type CC's were installed by dealers.
>>>> > >
>>>> > > Bob Stevens
>>>> > > '87 Syncro Westy
>>>> > >
>>>> > > > I've posted some pics of the thing to a spare page on my website
>>>> here:
>>>> > > The
>>>> > > > Thing - http://tinyurl.com/6dlp4d
>>>> > > >
>>>> > > > It also had a wire connected to the feed to the coil.
>>>> > > >
>>>> > > > TIA,
>>>> > > >
>>>> > > > Paul
>>>> > >
>>>> > >
>>>> > > ------------------------------
>>>> > > Use video conversation to talk face-to-face with Windows Live
>>>> Messenger. Get
>>>> > > started.<
>>>>
>>>> http://www.windowslive.com/messenger/connect_your_way.html?ocid=TXT_TAGLM_WL_Refresh_messenger_video_072008
>>>> >
>>>> > >
>>>>
>>>> ------------------------------
>>>> Making the world a better place one message at a time. Check out the i'm
>>>> Talkathon.<
>>>> http://www.imtalkathon.com/?source=EML_WLH_Talkathon_BetterPlace>
>>>>
>>>>
>>
>
|