Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2008, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Thu, 24 Jul 2008 21:17:22 -0700
Reply-To:   Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject:   Re: Engine Racing (not racing engine...)
Comments:   To: Evan Mac Donald <vanagon_dad@SBCGLOBAL.NET>
Content-Type:   text/plain; format=flowed; charset="iso-8859-1"; reply-type=original

there's a ball pivot at the end of the throttle cable where it connects to the transmission lever. I have seen these very rusted. Kinda buried up in there too, not real easyt to see or reach.........and they never get lubed....... might want to take a look at that part too. I also make it a standard practice to remove the forward part of the throttle cable from the white plastic tube in the van's body...........blow that tube out with compressed air ........then feed the cable back into the tube lubing it as it's inserted.

also the bell crank under the gas pedal.........and even junk around the gas pedal..........all that needs to be checked. to get at the forward end of the throttle cable, remove the spare tire, remove the cover from the bell crank ( 4 phillips screws ) ........and clean and lube that area over well. scott ----- Original Message ----- From: "Evan Mac Donald" <vanagon_dad@SBCGLOBAL.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Thursday, July 24, 2008 8:34 PM Subject: Re: Engine Racing (not racing engine...)

> O.K. there are a couple of places to look. I won't even come close to > covering all of the places, but here should be a start - > > 1) Open the engine cover, and look at the throttle shaft. If you are in > doubt, (with the engine OFF) have somebody press on the gas pedal, and see > what moves. It should be on the top of the engine, forward, and slightly > to right of center. What you are looking for is a long spring, slightly > larger in diameter than a regular pencil. It should be attached at one end > to the mechanism at the top of the throttle, and to the intake plenum on > the other. This check is easy, and doesn't require much in the way of > "dirty hands". > > 2) If the spring is in place, and stretches when the gas pedal is pressed > on, try next rotating that throttle by hand. There should be some > resistance, because there are actually TWO springs on it, but it should be > smooth, with no catches or drag. If it won't return easily, you may be > suffering from a worn-out throttle body. Common. Relatively easy to get > fixed, but kind of expensive. > > If both of the previous tests are good, then the problem will require > more effort to check. Under the van you go! > > 3) Have somebody ready to press on the gas pedal - again. On the right > side of the transmission, right in front of the drive axles, is a lever > that the throttle cable attaches to. To find it, have somebody press on > the gas pedal, and watch what moves. There are two big things that mey be > wrong under here. One is the cable itself. The little rubber boot at the > end of the housing rots away after a time, and the cable rusts into its > housing. Or, it can start to break, and the frayed ends jam in the > housing. Another may be the lever on the side of the transmission that the > cable attatches to. This is not really likely, but possible. To check this > lever's action, gently tug on the lever. It should move, a little, without > feeling too stiff , or "locked up" (My '84 did this to me...) > > These are relatively easy to check, and the answers from these checks can > help decide what to do next... > > > > Kevin Gilbert <kggilbert@MYACTV.NET> wrote: > Vanafolks, > > My 1.9L ('84, @112,000 mi., AT) does not kick down the rpm when > stopping. Makes for interesting stops. I have to throw it into > neutral and give the accelerator a hard punch to drop the rpm. > > Tell me what to check. > > Thanks. > > Kevin


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.