Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2008, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 22 Jul 2008 05:39:11 -0700
Reply-To:     dylan friedman <insyncro@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         dylan friedman <insyncro@YAHOO.COM>
Subject:      Re: The DEEP, DARK secret of fiberglass exhaust wrap discovered
Comments: To: Chris S <szpejankowski@GMAIL.COM>
Content-Type: text/plain; charset=us-ascii

Header wrap is not to be used by itself. Use a sealer to keep the water out. DEI makes a very good sealant and comes in colors. I have written about this numerous time and it is in the archives here and in the Subie swap forums.

All my exhaust systems have some wrap on them and have been sealed properly. No Rust at all. I have checked.

When driving in the rain, drag you brakes for a couple thousand feet before stopping and let the van idle for a minute or two after reaching your destination to keep water out of the brake system and rust the pads to the drums and heat the wrap up enough to remove the water from it.

dylan

----- Original Message ---- From: Chris S <szpejankowski@GMAIL.COM> To: vanagon@GERRY.VANAGON.COM Sent: Monday, July 21, 2008 10:24:31 PM Subject: The DEEP, DARK secret of fiberglass exhaust wrap discovered

Well, I bought some exhaust wrap, but not to wrap my exhaust, mind you. I needed to shield some not-so-hot parts from the hotter-than-H parts. I've read reports of exhaust headers rusting very quickly after application of fiberglass exhaust wrap. Why? The stuff soaks up water like a sponge and holds it. Yes, I just tested it. So you can imagine what happens over night when the dew point drops, no? Yes. The doom of all bare steel, moisture, gets sucked up against the headers.

It seems that sealing it against moisture would be the correct way to apply the stuff, which can be done by applying the appropriate and expensive sealant.

No problem for stainless steel headers, right? Maybe not so, since the wrap causes the temperature of the headers go up, which may be too much of heat stress for the metal to handle. And that might be another DEEP, DARK secret in itself.

Chris S.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.