VANAGON archives -- August 2008, week 1 (#211)

Date:         Sun, 3 Aug 2008 08:53:55 -0500
Reply-To:     Jim Felder <jim.felder@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <jim.felder@GMAIL.COM>
Subject:      Re: Question about pulley-crank end reassembly 2.1
Comments: To: Benny boy <huotb@videotron.ca>
In-Reply-To:  <vanagon%2008080223110876@GERRY.VANAGON.COM>
Content-Type: text/plain; charset=ISO-8859-1

Good! Exactly what I wanted. One more thing, how do you hold the crank to
tighten the bolt, with a conventional flywheel lock or with a pin through
the sight hole in the block and a flywheel hole? Or does it matter?
Jim

On Sat, Aug 2, 2008 at 10:08 PM, Benny boy <huotb@videotron.ca> wrote:

> 1-Steel washer
> 2-Rubber ring
> 3-crankshaft seal
> 4-woodruff key
> 5-Pulley
> 6-Bolt
>
> Ben
> http://www.benplace.com/vw2.htm
>
>
> >1. The pulley, of course.
> >2. The woodruff key with the flat end.
> >3. a round steel washer with the outer edges clipped into four flats
> >4. a rubber sealing ring
> >5. A crankshaft seal
> >6. the bolt.
>

Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.