Not quite the same, but I did this with a jigsaw: http://tubaneil.googlepages.com/RadHoleCut-outMarks.jpg/RadHoleCut-outMarks-full;init:.jpg http://tubaneil.googlepages.com/RadHoleCut-out.jpg/RadHoleCut-out-full;init:.jpg I second the motion for jigsaw. I used a higher count "metal" blade. Cheers, Neil. On Fri, Aug 8, 2008 at 3:16 AM, craig cowan <phishman068@gmail.com> wrote: > I'm at the point where i will son be cutting the hole for the fridge flu, > and wondering "How they did that"? > I was always under the impression it was a round hole.......it is however, > far from it. So what's the best method of cutting it accurately? > It's probably too thick for tin snips, a sawzaw would be too rough, a series > of hole saws could get you close, there must be a trick. > > What have people done!?!? > > -Craig > '85GL (Half Westy) > '80Westy (Half rust) > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.