Date:         Tue, 12 Aug 2008 12:23:04 -0600
Reply-To:     miguel pacheco <mundopacheco@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         miguel pacheco <mundopacheco@GMAIL.COM>
Subject:      CV Bolt Lock Plates
Content-Type: text/plain; charset=UTF-8

I have always reused these when replacing, rebuilding, etc. the CV
Joints. This time I think I accidentally tossed them and it brings up
this question :
I realize they probably achieve their description, but I have the
Syncro at a remote location, awaiting the rear axles I just rebooted
and repacked and I will likely not have the Bolt Lock Plates in hand
when I'm ready to throw them back on. It must be ok to run them
without these plates for a few miles......right?

--
Gracias,
                    Miguel

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.