Replaced the high pressure switch and want to test for leaks before putting my new belts back on. I have a couple of ?s...(1)How do I seal the connection from the wire to the sensor? Connector is good but might open w/vibration. (2)Since I have all belts off, thought I would put alternator on and tighten then run for awhile to check leak at switch. Then put on all other belts and proceed to fuel line replacement and tune-up. Any advice would be appreciated. Thx.
Michael in San Antonio 91GL AT 'Gringo' w A/C |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.