Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2008, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 24 Aug 2008 22:15:13 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
Comments:     RFC822 error: <W> MESSAGE-ID field duplicated. Last occurrence
              was retained.
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: Oil Pressure Switch
In-Reply-To:  <71d9cdf90808241350h346ac747j4d5f9bbcfa0dd938@mail.gmail.com>
Content-Type: text/plain; charset="iso-8859-1"

Teflon tape should only be used on fittings designed for the threads to make a seal. This is mostly tapered thread fittings such as used on pipe.

The oil pressure switch adapter (bushing) is a fine thread that relies mostly on the copper washer for a seal. Here a quality thread sealant such as loct-tite thread and flange sealant (anaerobic) will seal this up for good. It will also prevent it form working out next time the pressure switch needs to be changed.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Jake de Villiers Sent: Sunday, August 24, 2008 4:50 PM To: vanagon@GERRY.VANAGON.COM Subject: Re: Oil Pressure Switch

Teflon tape works well for me on fittings like that. You should probably replace the copper washer too.

On Sun, Aug 24, 2008 at 12:25 PM, Michael Sullivan <sandwichhead@gmail.com>wrote:

> Hi, All. When I pulled the high pressure switch, I also removed the > bushing > to the block. I cleaned both and reinstalled bushing(old w/copper > washer), > then the new switch. Put on the laternator belt and tested for leaks and > seems I have one. Will remove switch and bushing again and wanted to know > if new crush washer needed on bushing. Want this DONE. Will remove belts > again as I replaced w/new 1 hour ago and easier to reach switch. > BTW-24mm deep socket and thin 1/2 drive and switch is OUT! No bending and > no > muffler probs. Really easy with belts off. > Please advise opinions ASAP. Thx. > > -- > Michael in San Antonio > 91GL AT 'Gringo' >

-- Jake 1984 Vanagon GL 1986 Westy Weekender "Dixie" Crescent Beach, BC www.crescentbeachguitar.com http://subyjake.googlepages.com/mydixiedarlin%27


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.