Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2008, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 25 Aug 2008 12:53:09 -0500
Reply-To:     Jim Felder <jim.felder@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <jim.felder@GMAIL.COM>
Subject:      Re: Has anyone added a sliding 2 person Middle seat to a westy?
Comments: To: JordanVw@aol.com
In-Reply-To:  <c39.3cd12f44.35e44a46@aol.com>
Content-Type: text/plain; charset=ISO-8859-1

Chris, I think you mean a circular saw, there's the source of the confusion. A radial arm saw is a big floor-standing device where you put the wood on a table and move the saw, which is guided by a sturdy overhead arm. A typical homeowner model will make an 18 inch cut, an industrial model will make a 25 cut.

Surely you mean a circular saw, designed to be hand held and usually hand-guided, they weigh about 10 pounds. They are not affixed to any kind of table, generally.

?

Jim

On Mon, Aug 25, 2008 at 12:47 PM, <JordanVw@aol.com> wrote: > In a message dated 8/25/08 1:11:01 PM Eastern Daylight Time, > jim.felder@GMAIL.COM writes: > > > > It's pouring down rain here (finally) so I'm going from memory a > couple of years , but I'm trying to determine if there was one length > of rail made for nonwesties and another length made for westies. > > the ones I have came from a GL. I have a westy. If I were to install > my rails without trimming them, they would extend under the stove > cabinet an inch or so. Since I have never seen a factory installation > of these in a westy, I am not sure how it was done or it it makes any > difference. > > Question: if you don't need to remove cabinets, and you are suggesting > the use of a radial arm saw, are you saying that the floor will come > out without removing cabinets? > > > trim down the rails. they only need to be as long as the middle seat. > there is no reason they need to extend under the kitchen unit. > > set the radial arm saw to only cut thru the plywood floor, not into the > metal (obviously) > the plywood strips will just pop out. leave a 1/4 " gap on each side so the > seat can slide on. > the rails bolt to the floor with the regular 17mm seatbelt bolts > > > ************** > It's only a deal if it's where you want to go. Find your travel deal here. > (http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.