Date:         Tue, 2 Sep 2008 05:05:39 -0700
Reply-To:     dylan friedman <insyncro@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         dylan friedman <insyncro@YAHOO.COM>
Subject:      Re: Water Pump, lower bolt...
Comments: To: RAlanen@AOL.COM
Content-Type: text/plain; charset=us-ascii

I use 1/4" sockets, a flex shaft or extension with a universal swivel on the end.
Works fine.
No need to remove oil cooler with this setup.

dylan



----- Original Message ----
From: Frank Condelli <RAlanen@AOL.COM>
To: vanagon@GERRY.VANAGON.COM
Sent: Tuesday, September 2, 2008 6:49:39 AM
Subject: Re: Water Pump, lower bolt...

In a message dated 30/08/2008 9:02:43 P.M. Central Standard Time,
LISTSERV@GERRY.VANAGON.COM writes:

        If you cannot get a socket  on that nut then the oil cooler is needs
to move.  DANGEROUS,  as once  you loosen the big nut holding the oil cooler
the O-ring behind it may not seal  again so you may end up having to change
that O-ring, then your into a  bigger job.  It's most likely the elbow hose
that's preventing you from  getting in there with the socket.  Try to push a litter
harder so the  socket will pass by that hose so you won't have to loosen the
big nut on the oil  cooler.





>>>>>Any tips for reinstalling the lower of the 3 bolts  in the water pump
for a
2.1 Litre ? There does not seem to be enough room  between the edge of the
housing to get a socket on on the  nut...<<<<<<<





Cheers,

Frank  Condelli
Almonte, Ontario, Canada
'87 Westy & Lionel Trains (_Collection for sale_
(http://members.aol.com/Fkc43/trainsal.htm) )
_Frank Condelli &  Associates_ (http://members.aol.com/Fkc43/busindex.html)
- Vanagon/Vanagon Westfalia Service in the Ottawa Valley
_Vanagon Stainless Steel Exhaust  Systems_
(http://members.aol.com/Fkc43/exhaust.htm)
_BusFusion_ (http://members.aol.com/BusFusion/bfhome.htm)  a VW Camper
camping event, Almonte, ON, June 12 ~ 15,  2008