This likely goes without saying, but.... Maybe a piece of wood (hardwood?) and your bp hammer would be best for tapping in the new bushing. For sure they're brittle. Cheers, Neil. On Sat, Sep 13, 2008 at 4:58 PM, Walter Houle <whoule@ecscontrols.com> wrote: > My starter swap was going fine until I crunched the new bushing while > tapping it in. Everything was going fine up until that point. I searched > the archives and used the tap trick to remove the old bushing. I was using > an old steel clutch pilot tool and a small ball peen hammer to seat the > new one. They are pretty fragile I guess. Are replacement bushings readily |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.