Date:         Wed, 10 Sep 2008 06:25:19 -0700
Reply-To:     Stephen Grisanti <bike2vcu@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Stephen Grisanti <bike2vcu@YAHOO.COM>
Subject:      Re: Fuel Pump terminal plug-in
Comments: To: Chris S <szpejankowski@GMAIL.COM>
In-Reply-To:  <5ebe10a0809091759i3838446ckfb6e437ed97d9896@mail.gmail.com>
Content-Type: text/plain; charset=iso-8859-1

I don't know if it will run backwards, but mine did have a + and a - molded into the plastic near the terminals.  I had tagged the wires upper and lower but did not know which was the +  or - terminal.  I could recall the mounting orientation by the dirt/undercoating/clamp marks from the mounting bracket on the pump body and it worked fine when reinstalled.
 
Stephen

--- On Tue, 9/9/08, Chris S <szpejankowski@GMAIL.COM> wrote:

From: Chris S <szpejankowski@GMAIL.COM>
Subject: Fuel Pump terminal plug-in
To: vanagon@GERRY.VANAGON.COM
Date: Tuesday, September 9, 2008, 8:59 PM

Since I upgraded my engine and harness to 2.1 I also installed a 2-wire fuel
pump power/ground hook up.

The question... which is which plug at the fuel pump?  I don't recall
seeing
any + or - signs on the fuel pump body.   Does the fuel pump run backwards
if you get them backwards?

I have the battery in and now am cranking my newly installed engine, so I
want to make sure I'm pumping fuel in the right direction.

--
Chris S.
Disclaimer: "Death and serious injury may occur"