Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2008, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 21 Sep 2008 14:28:22 -0400
Reply-To:     pickle vanagon <greenvanagon@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         pickle vanagon <greenvanagon@GMAIL.COM>
Subject:      Re: Van Stalls Easily when totally cold.
Comments: To: Greg Potts <greg@pottsfamily.ca>
In-Reply-To:  <48D45F52.7080202@pottsfamily.ca>
Content-Type: text/plain; charset=ISO-8859-1

Greg, I meant to respond to this earlier. My sensor does check out with the bentley chart. My symptoms are also not quite what I think temp-2 sensor issures are. My idle, when cold, is still a very good idle, it just is too low. So for example, if I back out the throttle adjustment screw, I can make the cold idle perfect. But then the warm idle will be too high.

Thanks, for the suggestion though. Last time I had a cold idle problem (different van), it was this sensor. -Wes

On Fri, Sep 19, 2008 at 10:26 PM, Greg Potts <greg@pottsfamily.ca> wrote:

> Hi Wes, > > Have you checked the resistance of the temp sensor against the values shown > in the Bentley? An "extra" may or may not be within specs. > > Mine is doing much the same thing... Today I picked up a new temp sender to > be installed tomorrow. > > Happy Trails, > > Greg Potts > 1973/74/79 Westfakia "Bob the Tomato" > 1987 Wolfsburg Weekender Hardtop > www.busesofthecorn.com > www.pottsfamily.ca > > > > pickle vanagon wrote: > >> Lately, our westy has exhibited difficulty maintaining its idle in the >> first >> minute or so of cold running. It idles very low during this period, and >> if >> you don't nurse it, will cut out. (For example, if you rev the engine, >> then >> when it comes back down it will probably die). >> >> After 1-2 minutes, everything is perfectly peachy. Gas mileage is still >> very high. >> >> I've tried: >> swapping out the temp 2 sensor with an extra one >> setting the warm idle rate to spec (850 rpms) with the adjustment screw >> with >> the stabilizer bypassed >> a new idle stabilizer (needed one anyways because the plastic tabs broke >> off >> mine) >> checking the idle switch (it clicks and functions correctly, at least >> engine >> breaking fuel shutoff works) >> >> Any suggestions on where to go next? >> >> Thanks very much, >> Wes >> >> > > -- >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.