OK...Switched out new fuel hoses and FI seals in the engine compartment yesterday. All went well until reinstalling left side fuel rail. I over-torqued and sheared off the bolt. Went out and bought a new drill at Sears and a few bits and a flexible/bendable extension at Northern Tool and Harbour Freight. Can't seem to drill into the sheared bolt too well in order to get the Screw-out in. Will be heading to Lowes when they open and try to get a better bit. Any other suggestions? -- Michael in San Antonio 91GL AT 'Gringo' |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.