I have an 82 aircooled CA Westy, My van used to run fine, a stumbling at light load turned into it not starting any more. This is the only malfunction I can find in the system is... I have =battery voltage(12v) at the + injector connector(to ground) on the wiring harness, key on, but no signal (using LED voltage tester) when turning engine over(connector + to connector ground at ECU using test light). I have continuity on; each wire in the harness& all three grounds on the ECU. I have voltage to the ECU I'm assuming it's the ECU and am in the process of getting it replaced. THE QUESTION IS... Is there any other component, or combination of components that gives the ECU the signal when to fire the injector??? That may be the culprit for not getting a signal at the injector? |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.