Date:         Thu, 20 Nov 2008 08:15:18 -0800
Reply-To:     Don Hanson <dhanson@GORGE.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Don Hanson <dhanson@GORGE.NET>
Subject:      Oil cooling..
Content-Type: text/plain; charset="Windows-1252"

  There are 'tempostats' available to control your oil flow to an aux. oil
cooler.   Thermo-switches. a good

http://www.batinc.net/main.htm

source for Mocal and Tilton parts as well as all kinds of AN and AN/metric
adapters and hoses, etc.
 Plenty easy to set-up an effective oil cooling system to run at most any
temperature you choose.
  Mocal makes a plate adapter to go between your engine block and stock oil
filter.  The adapter has an outlet to plumb your oil cooler in and out.  A
check valve, a switch of some sort to allow normal warming of the oil in the
motor and you are all set.  If your oil runs hotter than about 300f..not so
good.   An oil temp gauge is easy to install.  I usually tap right into the
oil drain plug..keeps the drill shavings out of the motor.  BAT is a source
for extra drain plugs in metric and VW/Porsche sizes, too.
  I built an oil cooling system for my racecar (sourcing the parts from BAT)
taking the oil out at the Transmission drain plug and putting it back in at
the filler plug.  A Mocal cooler and a Tilton pump.  Brought my tranny oil
temp down from 300+ to ~180 and greatly extended the life of my gears..
  Haven't seen a need for extra cooling in my inline four gas motored
vanagon.
  Don Hanson

------------------------------------------------------------
+    To unsubscribe from the Vanagon List send an e-mail to
+    listserv@gerry.vanagon.com with SIGNOFF VANAGON
+    in the body of the message.
------------------------------------------------------------