Date: Sun, 23 Nov 2008 19:36:20 -0800
Reply-To: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Scott Daniel - Turbovans <scottdaniel@TURBOVANS.COM>
Subject: Re: Engine runs with no AFM?
Content-Type: text/plain; charset="iso-8859-1"
smiles -
Even though you now carry decent tools..................you may still get to have some great Vanagon break-down stories. I did start a car by only touching it with a plastic comb once . It's cheating to have the really right tools along, but I wouldn't venture out of town without a pretty full set, plus spare parts etc.
Sure is handy they made the rear hatch work as a perfect weather shield for those breakdowns in rain and snow. Very smart those VW engineers.
Scott
----- Original Message -----
From: craig cowan
To: Scott Daniel - Turbovans
Cc: vanagon@gerry.vanagon.com
Sent: Sunday, November 23, 2008 7:23 PM
Subject: Re: Engine runs with no AFM?
To be fair, i have learned my lesson, and now carry every tool necessary to rebuild an engine. Its great when you're broken down in a muddy parking lot in michigan, to be able to choose between 3 different drive sizes, deep well, 6points, etc : )
Not to mention screw drivers, spare parts, etc.
Hey the bus is older than I am....
It took a little while to learn!
-Craig
'85Gl gone Westy
On Sun, Nov 23, 2008 at 10:17 PM, Scott Daniel - Turbovans <scottdaniel@turbovans.com> wrote:
Driving a 20 + year old Volkswagen Vangon without even a screw driver on board !!??
are you nuts ?!
Reminds me of people that drive these old beauties without even a flashlight on board.
( not to mention a fire extinguisher or two )
LOL -:)
Scott
----- Original Message -----
From: craig cowan
To: Scott Daniel - Turbovans
Cc: vanagon@gerry.vanagon.com
Sent: Sunday, November 23, 2008 7:12 PM
Subject: Re: Engine runs with no AFM?
I had an AFM fall off my '85 on the way home from the opening showing of "LITTLE MISS SUNSHINE" with some friends. That made for a great story....
It did work, it just ran rough and was very slow to respond to throttle so almost impossible to start on a hill. I ended up pulling over, and fixing it with a quarter (i didn't have a screwdriver to tighten the hoseclamp, only a quarter).
-Craig
'85GL turned WESTY
On Sun, Nov 23, 2008 at 9:59 PM, Scott Daniel - Turbovans <scottdaniel@turbovans.com> wrote:
Actually, you can drive around half decently.
It's not hard to forget that last step of plugging the connector onto the
AFM of course, which is how I found out.
They run quite well, though unevenly, especially with a lot of pedal
applied.
I doubt that it hurts anything. The ECU is just temporarily confused about
how long to hold open the injectors. I imagine it overcorrects a bit.
Also...........WOT is a mode that bypasses some inputs I believe. It'll run
that way fairly well.
Scott
----- Original Message -----
From: "David Milo" <dellaone@GMAIL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Sunday, November 23, 2008 6:15 PM
Subject: Re: Engine runs with no AFM?
Yes indeed,
It will run, and you can even move the van around for short distances, but
I
wouldn't recommend it.
Dave Milo
On Sun, Nov 23, 2008 at 6:41 PM, Edward Maglott <
emaglott@buncombe.main.nc.us> wrote:
I was working on the van yesterday and had the AFM disconnected from
everything to look for a water leak in the area of the coolant
distributor. It's a strange leak that stops when the engine warms
up. So I decided to start the engine and take a look under
there. Turned the key and got a horrible noise since the air cleaner
housing was sitting on the alternator fan. D'oh! OK, moved that and
started the engine and it ran. So no air going into the engine was
going through the AFM and the AFM was not connected electrically
either. Hmmm, I thought. Must be the idle circuit keeping it
running. I opened the throttle and expected it to die, but no, it
revved up just like normal. Engine was cold, so was in open loop
mode, but still. Maybe since it had no load on it the engine was
able to spin up? Seems like it would have gone terribly lean. Any
ideas on this curiosity? This is a 2.1 digifant.
Edward
------------------------------------------------------------
+ To unsubscribe from the Vanagon List send an e-mail to
+ listserv@gerry.vanagon.com with SIGNOFF VANAGON
+ in the body of the message.
------------------------------------------------------------
------------------------------------------------------------
+ To unsubscribe from the Vanagon List send an e-mail to
+ listserv@gerry.vanagon.com with SIGNOFF VANAGON
+ in the body of the message.
------------------------------------------------------------
------------------------------------------------------------
+ To unsubscribe from the Vanagon List send an e-mail to
+ listserv@gerry.vanagon.com with SIGNOFF VANAGON
+ in the body of the message.
------------------------------------------------------------
------------------------------------------------------------
+ To unsubscribe from the Vanagon List send an e-mail to
+ listserv@gerry.vanagon.com with SIGNOFF VANAGON
+ in the body of the message.
------------------------------------------------------------