Date: Sun, 23 Nov 2008 23:57:40 -0500
Reply-To: "Daniel L. Katz" <katzd54@YAHOO.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: "Daniel L. Katz" <katzd54@YAHOO.COM>
Subject: Re: What is the best grease for CV joints?
ed:
excellent choice, but with a temperature range down to only -25 F, i
wonder if valvoline's synpower synthetic grease might be necessary, or at
least desireable, for vehicles operated in really cold climates, such as
the - 57 F which i recall from my long ago wyoming days.
http://www.valvoline.com/pages/products/product_detail.asp?product=59
i've used synpower successfully on cv joints, but i'm going to use
duroblend myself next time; in fact, i might pick up a tube just to see if
it is significantly more tacky than synpower, which doesn't seem to be as
tacky as official cv grease.
also, for anyone happening on this post, can you recommend a fast curing
urethane adhesive/sealer for use sealing the pinhole left in neoprine cv
boots after using a needle to inject grease (yes, a no no, but done
carefully, the technique has worked well for me over the years)?
thanks,
dan
http://www.valvoline.com/pages/products/product_detail.asp?product=59
On Sat, 22 Nov 2008 22:57:08 -0500, email99 <email99@BELLSOUTH.NET> wrote:
>What is the best grease for CV joints?
>
>It goes without saying that it is imperative to use the proper
>molybdenum enhanced high-temperature CV joint specified EP (extreme
>pressure) grease in constant velocity joints. Regular grease should
>never be used. It's also important not to mix molybdenum enhanced
>grease with regular grease because it will cause increased corrosion.
>
>So, what is the best type of CV joint grease? I have been greasing CV
>joints for more than 36 years on my personal cars and my experience is
>that Valvoline DuroBlend synthetic grease is superior to any regular,
>non-synthetic, molybdenum enhanced CV joint grease I have ever used. I
>have used it to reinstall CV joints that were damaged in 30k miles with
>traditional CV joint grease, showing significant galling and pitting.
>On reinspection of the same joints 70K later I found they had no
>additional wear evident and I reinstalled them after regreasing and they
>are still running.
>
>http://www.valvoline.com/pages/products/product_detail.asp?product=3
>
>Everyone has their personal preferences and I'm sure there are other
>high quality CV joint greases available. This is just my personal
>recommendation of a superior product that is significantly better than
>anything I have ever used.
>
>I have no connection with Valvoline or any other manufacture of anything.
>
>Ed McLean
>
>------------------------------------------------------------
>+ To unsubscribe from the Vanagon List send an e-mail to
>+ listserv@gerry.vanagon.com with SIGNOFF VANAGON
>+ in the body of the message.
>------------------------------------------------------------
------------------------------------------------------------
+ To unsubscribe from the Vanagon List send an e-mail to
+ listserv@gerry.vanagon.com with SIGNOFF VANAGON
+ in the body of the message.
------------------------------------------------------------
|