I had my vent frames powder coated, and the old rubber was still good enough. Treating the rubber with 303 Protectorant made a huge (positive) difference. That stuff really is good, and I do think, much better than Armor All. Putting the rubber back on the frame is a matter of first slipping the rubber over the upper pivot part that juts out (I drilled through the rivet that was there, and bought new rivets, which reminds me.. what sort of tool do I get to put the new rivets in?), then you need to bring the rubber firmly up into the inner top corner, and to get the vertical side of the frame fitted with the rubber, the outer side needs to be held in, while you push in the inner side. Its important to work from the top to the bottom, and (before and after) to slide-against-while-pulling, the remaining two sides, so the top and bottom corners of this vertical side have the rubber securely in place without a gap (so you're pulling along the two sides that join in the front corner, and in each case, pulling away from this front corner). Next time I really should get all new rubber, and Volkscafe (Van Cafe -- really, maybe it should be called V-Cafe -- a plain V sounds like Vee... but without any potential trademarking conflicts of VeeDub... Its kind of abstract too, -- there's a new place in Newport Beach, called the A Market. Of course the "A" is a little fancy looking, but really, its a nice place, upscale casual, great vegtables, decent cookies) has a good deal on rubber. I also noticed that jutted metal meant for the bottom, or lower, pivot point, on both side, is bent outward, at the bottom-rear, as if someone, sometime, had forced open the vent windows more than they were meant to be opened... and so the metal tab bent, and then the alignment of the pivot point was off enough, so that upon closing, the lower front corner of the wing glass won't close securely, and thus becomes a source of wind noise (though not the only). So I'm going to bend these tabs straight again... In case you missed it, I've got a Rivet tool question buried in this... ------------------------------------------------------------ + To unsubscribe from the Vanagon List send an e-mail to + listserv@gerry.vanagon.com with SIGNOFF VANAGON + in the body of the message. ------------------------------------------------------------ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.