Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2009, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 29 Jan 2009 12:12:27 -0800
Reply-To:     neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil N <musomuso@GMAIL.COM>
Subject:      Re: Lower Ball Joint Adaptor Questions (PICS)
Comments: To: craig cowan <phishman068@gmail.com>
In-Reply-To:  <d1ea9acf0901290801l7b400060s6e34bd856b5f0239@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

On Thu, Jan 29, 2009 at 8:01 AM, craig cowan <phishman068@gmail.com> wrote: > If you were creative enough, you could set up propane or mapp gas with a > compressed air setup instead of the small oxygen tanks. Compressed > atmospheric air is just about as good. I have a torch like this that we just > cut the hose, and attached to the air compressor.... > thus giving you a limitless supply of air, and you just have to replace the > Mapp gas tanks. Heck my jewelry studio is run on compressed air and natural > gas.... > It's plenty hot enough for most things, and it's just about as close as you > can get to limitless. > > I still recommend the $50 homedepot setup. It's hot. > > -Craig

Thanks for the pointers guys.

Craig I know what you mean. Where I apprenticed repairing horns and making trombone bells, the owner had an air compressor + propane setup for silver and bronze brazing. For various reasons, I won't be setting up anything like that, or oxy/acetylene, here. Still, that setup worked fine.

I'll likely swap in my the somewhat "unknown" used lower control arm.

Cheers,

Neil.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.