Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2009, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 2 Mar 2009 08:33:09 -0500
Reply-To:     Greg Potts <greg@POTTSFAMILY.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Greg Potts <greg@POTTSFAMILY.CA>
Subject:      Re: Engine stutters, tach nosedives. Then, just as suddenly,
              it's,normal again.
Comments: To: Jerry <jbvelo@BELLSOUTH.NET>
In-Reply-To:  <C5D0D294.6E8%jbvelo@bellsouth.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Hi Jerry,

That is an excellent idea; the problem is that it can only be implemented at a time when the failure is occurring.

So far the problem has been an occaisional inermittent issue, happening for at most 2-3 seconds (usually a lot less) while operating at highway speeds. There's no opportunity to get out and do any checking; the only instruments available for diagnosis are the tach and speedometer.

In the interest of piece of mind and public safety I would prefer to be proactive and resolve this issue BEFORE it puts me at roadside with a meter; so a new coil, cap, rotor, polug wires and distributor are soon to be installed.

Happy Trails,

Greg Potts 1973/74/79 Westfakia "Bob the Tomato" 1987 Wolfsburg Weekender Hardtop www.busesofthecorn.com www.pottsfamily.ca

Jerry wrote: > Why not perform the continuity and voltage > checks as listed in the Bentley. These tests will > check your coil, hall sender harness, ECU > and the hall sender. You can do all these checks > with volt/ohm meter. > > > JB 88GL Guido > > > On 3/1/09 11:36 PM, "David Beierl" <dbeierl@ATTGLOBAL.NET> wrote: > >> At 11:27 PM 3/1/2009, Scott Daniel - Turbovans wrote: >>> it would be interesting to rig a timing light so you can observe it while >>> driving. >> Actually, rigging a logic probe to the Hall sender input of the ECU >> would immediately tell whether the distributor/wiring is the culprit >> or not. Or a scope, of course. But last I knew Radio Shack sold a >> logic probe for $25. >> >> >> -- >> David Beierl - Providence RI USA -- http://pws.prserv.net/synergy/Vanagon/ >> '89 Po' White Star "Scamp" >

--


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.