Date:         Tue, 10 Mar 2009 09:21:22 -0500
Reply-To:     Jim Felder <jim.felder@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <jim.felder@GMAIL.COM>
Subject:      Re: Manual trans replacement
In-Reply-To:  <213330.50499.qm@web52103.mail.re2.yahoo.com>
Content-Type: text/plain; charset=ISO-8859-1

Pulling the pesky slave cylinder bracket: as was mentioned in the post
I trimmed, use a grinder to cut a cheap 13mm box wrench in half. Put
it over the pesky fastener underneath the bracket and stuff the
underside of the bracket with a rag or newspaper. Then it becomes an
easy job, giving you two free hands to unbolt with.

I've heard that lever doesn't come off so easily on a lot of vanagons.

Jim

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.