Hi all. I just installed new bearing races on my new rotors. A most excellent vision. All shiny and new. But.... For some reason, the grease seal for the inner bearing, won't stay in. Either tapping it in with a block of wood or pushing in by hand, it might seat partway, but promptly pops back out. Or part of it sinks too far in and it stays in cockeyed. There may have been too much grease on the outside face of inner bearing, so I cleared that away. That made no difference. Any tips on how to install it? Maybe I was sold the wrong seal......
Thanks! Neil. -- Neil Nicholson '81 VanaJetta 2.0 "Jaco" http://tubaneil.googlepages.com/ http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.