Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2009, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 20 Mar 2009 21:18:11 -0400
Reply-To:     Mike S <mikes@FLATSURFACE.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike S <mikes@FLATSURFACE.COM>
Subject:      Re: Front Wheel Bearing Seal Issue (Pic)
Comments: To: neil N <musomuso@GMAIL.COM>
In-Reply-To:  <c4e7c5f90903201755s6a284ab9j75849b375e9f9657@mail.gmail.co m>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 08:55 PM 3/20/2009, neil N wrote... >In filling the groove in the seal with some grease (and ensuring there >was enough grease in behind seal when installed)

That won't do any harm, but for next time, just put the seal in dry (or very lightly lubricated so it can be pushed in without tearing). There's no need to fill it with grease, all the grease you need can be put in after the seal is installed.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.