Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2009, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 23 Mar 2009 22:57:44 -0300
Reply-To:     Pascal <84westfalia@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Pascal <84westfalia@GMAIL.COM>
Subject:      Re: Front Oil Seal vs Flywheel Seal vs Bob Donalds Installation
              Video
Comments: To: John Rodgers <inua@charter.net>
In-Reply-To:  <49C2061F.4060600@charter.net>
Content-Type: text/plain; format=flowed; delsp=yes; charset=iso-8859-15

There is quite a write up on the main crank seal on the Go Westy site. The seals they sell are thicker than other available seals (12mm IIRC) and are the same ones the dealers sell apparently. I could actually see where the VW logo was ground off the seal on mine. Last year I asked Boston Bob about the proper way to install the thicker seal. He said just tap it in until it bottoms out.

Pascal '84Westy

On Thu, 19 Mar 2009 05:45:19 -0300, John Rodgers <inua@charter.net> wrote:

> Ok - 88 GL Manual Tranny is sitting on the shop floor on a dolly. > Flywheel removed, old oil seal removed, old pilot bearing removed, seat > for both cleaned up. Flywheel clutch disc contact face cleaned and > scuffed, new flywheel "O" ring installed, new pilot bearing greased and > installed, New oil seal put in place and tapped down per Bob Donalds and > bottomed out. > > But WTF! The new seal won't recess the 1/16 below the surface of the > case as Bob specifies! It only recesses 1/32 of an inch. Hmmm~wrong > seal perhaps? A quick call to Ken Wilford, my supplier for the seal. > raised an interesting queston. How did the seal supplied copair with > others of other brand names. Well, as it turns out the two after market > seals he sell and the genuine Volkswagen OEM seals he handles are all > the same thickness. So no discrepancy there. > > This raises a question. I understand fully why Bob insisted the seal be > recessed - to avoid ripping the thing out at some point and having to do > it all over again. So with this apparent difference between how the > seals are made vs how Bob says the need to be installed - it appears > there is something missing.if the information on how to get this done > best.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.