Date:         Thu, 26 Mar 2009 23:03:27 -0700
Reply-To:     neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil N <musomuso@GMAIL.COM>
Subject:      Re: Less expensive brand, was Re: Smaller Angle Grinder?
Comments: To: David Beierl <dbeierl@attglobal.net>
In-Reply-To:  <49cc67f7.04035a0a.2aad.ffffdcca@mx.google.com>
Content-Type: text/plain; charset=ISO-8859-1

On Thu, Mar 26, 2009 at 10:45 PM, David Beierl <dbeierl@attglobal.net> wrote:
> At 01:32 AM 3/27/2009, neil N wrote:
>>
>> Some of those cheaper ones have poor wire feed mechanisms.
>
> Like Century...
>
> Crying twice...the Miller cost a lot more, but it feeds smooth as silk.
>
> Crying three times...the Lincoln (that I haven't got) converts easily and
> cheaply to use aluminum wire.  The Miller...might as well buy another one.
>  But the Miller's prettier.
>
>



Yup. Cheap ain't no good!

But as I knew, and am learning in a different way, good tools will
never cure bad technique. (or at least a lack of knowledge)

Pretty interesting. My first time welding on a vehicle. The patch got
done and should hold fine, but ain't pretty.  <rolls eyes> Speaking of
"ain't pretty", I was so intense thinking about safety, work position
etc., I forgot to turn on the frickin shielding gas! My first pass
looked like pigeon excrement!

I need a dang lift. Welding a patch onto my Westy's subframe while
lying on my back holding my upper body in position (with like, zero
core muscles) and working with poor lighting sucked.

Yeesh!   ;)

;)

Neil.

--
Neil Nicholson '81 VanaJetta 2.0 "Jaco"

http://tubaneil.googlepages.com/

http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines