Date: Tue, 14 Apr 2009 08:41:33 -0400
Reply-To: Chris S <szpejankowski@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Chris S <szpejankowski@GMAIL.COM>
Subject: Re: Loss of Power after carwash
In-Reply-To: <eccfedcc0904131548ja31133q853d00d4cd8a1015@mail.gmail.com>
Content-Type: text/plain; charset=UTF-8
Michael,
I'm trying to envision in my head the systems you could have affected by
spraying the underside of your bus. If the engine splash shields are in
place, then I can only think of fuel lines, fuel pump with connectors, and
ground straps. I don't know where the charcoal canister/fuel vapor recovery
vacuum lines are on your model of bus, but I'd check that too. Those would
be the items I'd check first. Id start by lying down under the bus and
slowly looking at EVERYTHING.
It could also be a mere coincidence. Did you fill up with fuel just before
the wash? Bad gas? What if water got into the fuel system? A cheap
bottle of fuel dryer would answer that question.
2009/4/13 Michael Sullivan <sandwichhead@gmail.com>
> Well, still having the same loss of power. Gonna try step by step
> diagnosis. I unhooked the green wire from the o2 sensor, no change.
> Unhooked the harness from the o2 sensor and still no change. Will pull all
> electrical connections and dry and seal them, but wondering if I should try
> new plug wires. I have never changed them(owned van for a year and 12). I
> have a new dist cap, rotor, and plugs already. No hole in the exhaust.
> Will
> also pull the fuel filter tomorrow. This started happening after I rinsed
> the van by hand after trip to beach and used the hand sprayer to rinse
> undercarriage. Any other advice, please feel free. thanks alot.
>
> P.S. Texas VW Classic is next weekend in Fredericksburg, TX. Anyone nearby
> should try and make the trip. see www.vosaclub.org
> Michael in San Antonio
> 91GL AT 'Gringo'
> 73 Beetle
>
>
> On Tue, Apr 7, 2009 at 10:54 PM, Robert Stewart <robertmstewart@mac.com
> >wrote:
>
> > I had this exact experience in flood where it was pouring for days and
> > I drove the van into a puddle so large that when I drove through it
> > the water was over O2 sensor!
> >
> > Once I disconnected it the problem went away. Later when the van
> > dried out I reconnected it and it was fine.
> >
> > Robert
> > NY
> >
> >
> > On Apr 6, 2009, at 12:47 PM, Ken Lewis wrote:
> >
> > Mike,
> >> On more than one occasion I have heard of the O2 sensor and it's
> >> associated
> >> wiring getting wet and causing this problem. Try unplugging it until
> >> it
> >> dries out.
> >> Ken Lewis
> >> http://neksiwel.20m.com/
> >> in statu viae
> >>
> >
>
--
Chris S.
Disclaimer: "Death and serious injury may occur"
|