While I said roughly 4' x 4', the hole I would cut is 43" by 43", centered side to side and front to back within the 2 main arches. This puts the side cuts in the flat spots of the middle roof rib. My guess is that VW put those flat spots there for just this purpose. This facilitates a simple finish trim after a hole is cut. You need some flat edge all the way around the new opening. It is tempting for people to cut the hole a little small out of caution but this is a problem on the front edge since if you leave too much of a lip it blocks your hands from releasing the poptop latch comfortably. Leave a couple extra inches of the headliner to fold over the new edge, so cut it more like 40" x 40" and cut any excess after the finishing is worked out. Mark
mark drillock wrote: > I cut the hole and installed my first poptop 15 years ago to make my > Baja Syncro Camper. It has been offroad many many times, heavily loaded. > > As long as the roof arches are left alone, the roughly 4' x 4' hole cut > over the standing area is not a problem, in my experience. I have put > 150k miles on that Syncro since. I still have it and I have done the > same to a few others since that one. > > ............... |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.