Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2009, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 25 Apr 2009 10:21:09 -0700
Reply-To:     Doug Noganav <vanagon@ASTOUND.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Doug Noganav <vanagon@ASTOUND.NET>
Subject:      Re: gas fuel tank sealant repair needed
Comments: To: vanagonstretch@aol.com
Content-Type: text/plain; charset="iso-8859-1"


Thanks Gerry, 


I just picked up some PC7 epoxy paste, has anybody ever tried to THIN this stuff?


It says it wont run or sag, I NEED it to run down into the seam of the tank. 


Doug




  ----- Original Message ----- 
  From: vanagonstretch@aol.com 
  To: vanagon@ASTOUND.NET ; vanagon@GERRY.VANAGON.COM 
  Sent: Saturday, April 25, 2009 7:01 AM
  Subject: Re: gas fuel tank sealant repair needed




  I used JB Weld on my gas tank and it's been holding perfectly. Just make sure it's very clean before application.


  Cheers, Gerry
  www.vanalong.com








  ---- Original Message ----
  From: Doug Noganav <vanagon@ASTOUND.NET>
  To: vanagon@GERRY.VANAGON.COM
  Sent: Fri, 24 Apr 2009 9:56 pm
  Subject: gas fuel tank sealant repair needed




This is not directly for a fuel tank its for a parts washer tank which holds 
solvent. The bottom seam of the barrel is leaking at the seam where its crimped. 




There is a large grove in on the inside that can be filled. 


Thinking permatex, RTV, ? Epoxy?


Any suggestions?


Thanks,


Doug






------------------------------------------------------------------------------
  AOL Sessions - Watch in studio exclusive video performances from today's top artists.
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.