Hello Folks, I was checking through the archives where there is plenty of discussions about putting Audi dual piston calipers on. However, I could not find any reference to actual spacing in the Vanagon. I don't have one handy to measure so thought to ask you guys. In an effort to put the rumors to rest that the Audi S6 calipers will work on Vanagons w/o machinework, I acquired a set as part of an experiment. Without taking measurements, I can already see that the mounting holes are much smaller. It remains to be determined if the caliper spacing is even close. These look to be about just a hair under 3 3/4". I don't have a metric ruler or caliper handy so that is an estimate. -- BenT |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.