Date: Wed, 27 May 2009 19:57:18 EDT
Reply-To: Dvdclarksn@AOL.COM
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: David Clarkson <Dvdclarksn@AOL.COM>
Subject: intermittent rich running problem-summary so far
Content-Type: text/plain; charset="US-ASCII"
Thanks Dennis-good advise. I did clean up the ground near the coil which
has the larger ground strap for the engine. I'll try cleaning this other
ground as you suggested also. I also tried spraying the connections for the
temp II sensor with WD40 per previous suggestions. This seemed to possibly
have a short term effect. I will try shutting off and restarting while the
engine is turning to see if this changes anything. The O2 sensor voltage is
moving from about .1 to .7 volts. Someone prior to me had at one point
created a crude splice in the temp II sensor on the sensor end and I tried a few
years back to create a better splice/connection and may need to work on
that again. I am curious as to the best way to better this splice without
having undue effects on the resistance. Anyone have any ideas on how to best
repair a splice at the end of the harness going to the temp ii sensor. Thanks
everyone.
David
In a message dated 5/26/2009 11:00:02 P.M. Eastern Daylight Time,
d23haynes57@hotmail.com writes:
An easy way to diagnose if a mixture problem is due to the O2 sensor is to
turn the ignition off and back on while the engine is still turning. If the
problem clears for 30 seconds or so then the O2 sensor or wiring is the
problem. Also try full throttle (assuming the full throttle switch is
working). If you suddenly get the burst of power, again back to the O2. The
most important ground connection for the O2 is the brown wire that goes
through the distributor harness. If it is connected to the engine at one of
the oil breather tower screws, move it to something metal on both sides.
Check the ring terminal carefully. The crimp can look good but that
corroded
wire makes for a lousy connection. New ring terminals with the heat shrinks
ends will work wonders.
Dennis
-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
David Clarkson
Sent: Tuesday, May 26, 2009 11:04 AM
To: vanagon@GERRY.VANAGON.COM
Subject: intermittant rich running problem
Just a follow up to the previous post. The oxygen sensor voltage seems to
be swinging between .1-.7 volts with the engine warmed up. Thanks for any
help that you can offer fellow vanagonauts.
David
In a message dated 5/26/2009 10:34:31 A.M. Eastern Daylight Time,
Dvdclarksn@AOL.COM writes:
I'm having an intermittent rich running problem with my 90 2.1 liter
Westy.
This was the same symptom that I had that was fixed 13 mos. ago with a new
temp II sensor. This has been replaced with no effect. One other
interesting thing that I noticed when attempting to install a wire to
feed an oxygen
sensor monitor was that just connecting an additional wire to the sensor
causes an immediate rich running condition. I had a problem this morning
when the engine was started cold with running rich also. Am I looking at
a
problem involving cleaning up some grounds again. I'm thinking that I may
also
need to test the voltage coming from the sensor and also at the ECU. Any
ideas towards diagnosing this problem would be greatly appreciated.
David Clarkson
**************A Good Credit Score is 700 or Above. See yours in just 2
easy
steps!
(http://pr.atwola.com/promoclk/100126575x1222377034x1201454326/aol?redir=htt
p://www.freecreditreport.com/pm/default.aspx?sc=668072&hmpgID=62&bcd=
MaystepsfooterNO62)
**************A Good Credit Score is 700 or Above. See yours in just 2
easy
steps!
(http://pr.atwola.com/promoclk/100126575x1222377034x1201454326/aol?redir=htt
p://www.freecreditreport.com/pm/default.aspx?sc=668072&hmpgID=62&bcd=
MaystepsfooterNO62)
**************Dinner Made Easy Newsletter - Simple Meal Ideas for Your
Family. Sign Up Now!
(http://pr.atwola.com/promoclk/100126575x1221991367x1201443283/aol?redir=http:%2F%2Fad.doubleclick.net%2Fclk%3B215225819%3B37274678%3Bs%
3Fhttp:%2F%2Frecipes.dinnermadeeasy.com%2F%3FESRC%3D622)