On Sat, 6 Jun 2009 11:33:33 -0700, Edward Wiebe <wiebeis@SHAW.CA> wrote: >I recently decided to go for a Propex heater for my 1990 Wesfalia. I ordered it from Frank Condelli and got quick efficient service. Thanks, Frank. >I have installed it into that little space just before the Water tank. It is very tight and one has to move the electrics around a bit. It is in, but here is my problem. I put in a tee joint on the fridge propane line under the sink area. How does one get non leaky joints on these lines? I understand one is not to use Teflon tape and one is not to over tighten the nuts. What is the secret to getting them gas tight? >Any help appreciated. > >Ed Wiebe No secrets, just good practice: 1. Smooth cut. 2. Ream the interior of the cut, but don't over-do it. 3. Install the flare nut. Use long flare nuts only for gas; short flare nuts are for water, refrigeration lines, etc. Long flare nuts also have greater vibration resistance. 4. Proper placement of the tubing in the die; exactly flush with the face of the die will make a flare of the proper size. 5. Flaring is a cold-forging process, which will benefit from the smallest amount of oil between the mandrel (the cone-shaped part of the flaring tool) and the copper. Oil is not absolutely necessary, but beneficial. 6. Do not use excessive force in forming the flare; a too-thin flare may result, with small splits on the end 7. The thinnest film of oil on the end of the tubing and the threads of the nut will also aid in the proper tightening of the nut. As the brass nut begins to tighten against the copper tubing, the film of oil will reduce the friction between the two materials, and allow for a better feel of the amount of torque being applied. Again, the oil is not absolutely necessary, but it helps. Over-tightening flare fittings may result in the splitting of the tubing; just snug with a wrench, plus 1/6 turn is the rule of thumb. 7. Always test for leaks, at greater than operating pressure when possible. Thread sealant, be it pipe dope or Teflon tape, has no place with flare fittings. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.