Date: Mon, 8 Jun 2009 21:23:11 -0400
Reply-To: Jonathan Farrugia <jfarrugi@UMICH.EDU>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jonathan Farrugia <jfarrugi@UMICH.EDU>
Subject: Re: Help w/2.1 What am i missing?
In-Reply-To: <BAY126-W7B2669C827473B626FBE983440@phx.gbl>
Content-Type: MULTIPART/MIXED;
try starting it on ether. pull the relay for the fuel pump and spray some
ether in the intake boot after the afm.
jonathan
On Mon, 8 Jun 2009, Darren Lastfogel wrote:
> No back fire and my cat has been hollowed out by the PO years ago.
> I also replaced the cap and rotor and checked for spark and that looked good
> I can normally figure this stuff out, But this has me stumped
> Not even trying to fire.
> I will try again tomorrow and double check it all again
> Darren
>
>
>
>> Date: Mon, 8 Jun 2009 20:36:10 -0400
>> From: paullist08@GUZYK.COM
>> Subject: Re: Help w/2.1 What am i missing?
>> To: vanagon@GERRY.VANAGON.COM
>>
>> did you notice a backfire or other exhaust noise lately?
>>
>> a plugged CAT can cause a no run situation when you have fuel and spark...whack the cat, does it sound like anything broken inside?
>>
>> Put you hand on the taipipe. Have someone crank it over. Any sign of compression getting to the tailpipe?
>>
>> -----
>>
>> lately I've been seeing a lot of flakey 2.1 distributors... but when the hall sensor is bad you get no spark so your dizzy is probably ok.
>>
>>
>>
>>
>> ---------- Original Message ----------------------------------
>> From: Larry Alofs <lalofs@GMAIL.COM>
>> Reply-To: Larry Alofs <lalofs@GMAIL.COM>
>> Date: Mon, 8 Jun 2009 19:06:38 -0500
>>
>>> A few things occur to me:
>>>
>>> Was there gas at the tee, or could you have been measuring air pressure?
>>>
>>> When checking voltage pulses at the injectors, be sure to measure
>>> between the two injector wires; 12v should be on one continuously; the
>>> other gets intermittent ground from the ECU.
>>>
>>> Are your spark plugs in reasonably good shape?
>>>
>>> HTH
>>> Larry A.
>>>
>>>
>>>
>>> On Mon, Jun 8, 2009 at 6:17 PM, Darren Lastfogel<vr6vanagon@hotmail.com> wrote:
>>>> Started the van today, Drove 100 yds and it died. I was on my to fill up cause I was very low, so I thought I ran out of gas. I put in some new gas And It would not start, Checked my fuel pressure at the T and it was 35 psi I pinched the return line and watched it go over 80 before I released it, I checked spark and had it , Checked compression all over 110 psi, I checked voltage at the injectors with a dc voltage detector and saw it pulsing but still the van would not fire, not even try to fire.
>>>>
>>>>
>>>> Spark, Compression, Fuel, Air
>>>> What am I missing?
>>>>
>>>> Darren
>>>> Rockford MI
>>>> _________________________________________________________________
>>>> Insert movie times and more without leaving Hotmail®.
>>>> http://windowslive.com/Tutorial/Hotmail/QuickAdd?ocid=TXT_TAGLM_WL_HM_Tutorial_QuickAdd_062009
>>>
>
> _________________________________________________________________
> Windows Live™: Keep your life in sync.
> http://windowslive.com/explore?ocid=TXT_TAGLM_WL_BR_life_in_synch_062009
>
>
|