Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (June 2009, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 27 Jun 2009 20:13:19 -0700
Reply-To:     Anthony Egeln <regnsuzanne@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Anthony Egeln <regnsuzanne@YAHOO.COM>
Subject:      Re: Two Inch Coolant Hose
Comments: To: Scott Daniel - Turbovans <scottdaniel@turbovans.com>
Content-Type: text/plain; charset=iso-8859-1

According to my local dealer, this hose is NLA at VW, but Bus Depot had it and I got it shipped overnight.  Thanks to Ron and crew.

All installed and ready to rumble!  On closer inspection they had not replaced the housing.

Anthony '89 Syncro GL (Hidalgo)

--- On Sat, 6/27/09, Scott Daniel - Turbovans <scottdaniel@turbovans.com> wrote:

From: Scott Daniel - Turbovans <scottdaniel@turbovans.com> Subject: Re: Two Inch Coolant Hose To: "Anthony Egeln" <regnsuzanne@YAHOO.COM>, vanagon@GERRY.VANAGON.COM Date: Saturday, June 27, 2009, 2:58 PM

if the thermostat housing looks brand new, then they likely replaced it, which requires messing with that short hose.

The large end of that hose is not 'stretched' over the larger t-stat housing on one end. The hose is molded or built that way ......bigger on one end. Very clever of VW to do that on many of their  hoses............so straight generic hose can't work, and you have to buy the 'real' right part.

that hose is still available. ..........shouldn't be too hard to find. I'd get rid of those springy type hose clamps on it ( if still there ) ...........and use high quality, preferably german screw type hose clamps going back together. I vaguely remember that that hose is a bit of curse job to replace, even though it looks like it would be pretty easy to replace. Don't use amercian style screw hose clamps with sharp edges .........that sharp edge digs into the hose when well tightened. Good screw type hose clamps have slightly curled up edges to prevent that. have fun ! Scott www.turbovans.com

----- Original Message ----- From: "Anthony Egeln" <regnsuzanne@YAHOO.COM> To: <vanagon@GERRY.VANAGON.COM> Sent: Wednesday, June 24, 2009 1:14 PM Subject: Two Inch Coolant Hose

Hi List,

On my '89 Syncro wasserboxer, there is a two or so inch coolant hose that goes from just under the thermostat housing (at least I think it is the thermo housing) and goes aft to connect with a metal coolant line. This short piece of hose is leaking right where it attaches to the thermo housing.

It is odd because on the aft end it is hooked to an about 1/2 inch metal line, but then stretches out over a much bigger port (3/4 or so) on the thermo housing end.

I had a whole bunch of work done by my local VW experts last week and one of the tasks was to flush the coolant and replace the thermostat. Is it possible they replaced the thermostat housing (looks new) and forced the 2 inch piece on to the wrong thermo housing? Or does it sound just like a bad piece of hose that must be replaced.

We're getting into the Florida summer, so this is important to fix quick even though the leak is small now.

Thanks a lot,

Anthony '89 Syncro GL (Hidalgo)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.