If you won't drill holes it won't work. The 2 hinge straps need holes and there are I think at least 2 of the base holes than can be drilled and bolted through the floor. Mark Brendan Slevin wrote: > So I was trying to figure out if I can swap the Z-Bed from the 84 Wolfsburg > in to the 87 Syncro which only has the fold forward seat. It looks like the > syncro seat will bolt right into the 84, no problem. But the Syncro lacks > (I think) the threaded holes to bolt the seat bed to the floor of the van > and to the rear deck of the van. Is it possible at all to fit the Z-bed to > the syncro? I don't want to do much in the way of drilling/fabricating. > > Brendan > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.