Re: 1986 2WD 2.1- manual trans.
I having trouble replacing the short coolant line that feeds from the plastic distribution unit (pass side) to the last opening on the bleeder rail that encircles the engine compartment - doing a 180 deg turn. This line is only 4"-5" long and when I bend a length of coolant line, it nearly collapses on itself due to the tight bend. I also tried 7mm fuel line and it was slightly better. I longer length of line does not work any better.
Anyone else run into this? It's hose #27 on the diagram I found on-line. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.