Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2009, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 6 Jul 2009 20:23:54 -0400
Reply-To:     jeff ensing <jeffensing@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         jeff ensing <jeffensing@GMAIL.COM>
Subject:      Re: Tranny leak??
Comments: To: Scott Daniel - Turbovans <scottdaniel@turbovans.com>
In-Reply-To:  <00f001c9fe84$d4e22b60$6401a8c0@PROSPERITY>
Content-Type: text/plain; charset=ISO-8859-1

My first step would be to make sure the trans vent is open and 'breathing' or you might be in the same boat even with new seals.

jeff

On Mon, Jul 6, 2009 at 5:57 PM, Scott Daniel - Turbovans < scottdaniel@turbovans.com> wrote:

> a 2WD vanagon trans is not that hard to take out. > You need at least a smooth hard level surface, jack stands, and a floor > jack. Two floor jacks makes it super smooth, as transmission-removal jobs > go. > > at a shop ........I've seen shops charge up to 900 bucks for a vanagon > clutch job. Kinda depends on if they're a high-dollar fancy shop, or > trying > to be ......or if they're trying to deliver a lot of value and quality. > But > up to that much ......which is pretty 'high retail' pricing of course. > > the right way to proceed, is ...disassemble.......inspect carefully > everywhere .......then procure quality, usually german made parts, all that > are needed....... > and put it back together carefully. > the trans input shaft oil seal is pretty straightforward. > In the case of really good leaks though ..........I'm always concerned that > it's 'more than just a seal' . > Sure, sometimes it is just a seal, or seals, and sometimes it's more than > that. > Waterboxers ( if that's what you have ) often need new pilot bearings, and > sometimes the felt dust seal is missing, and sometimes a small retainer > ring > for that dust seal is missing. I see that on about half of the clutches I > do. That small ring is a part you can't get, not new anyway. > have fun, whatever you do ! > Scott > www.turbovans.com > > > ----- Original Message ----- > From: "Tom Jansen" <norgecastle@TX.RR.COM> > To: <vanagon@GERRY.VANAGON.COM> > Sent: Sunday, July 05, 2009 8:35 AM > Subject: Tranny leak?? > > > My 89 westy is leaking a lot of gear oil thru the rear / engine side. I > put in 2 qts last month and I would think it down a quart now after 500 > miles. Yes that much. Not driving it much till I can get this fixed. > Anyone had experience with removal and fixing? Should I do it myself or > the > shop? I have pulled many air cooled engines but stayed away from trannys > as > they worked. Can the seal be pulled with a screwdriver prying out? What > else should be replaced while apart.? Clutch disk? engine seals.? The > engine was rebuilt 5 years ago and 25k miles. Anyone with a brief walk > thru? / Jack up rear / support engine front / undo shifter, > bellhousing, nose, pull shafts / > replace main seal on tranny / replace soaked clutch disk / replace throw > out > bearing? / any engine seals while I have access to the face?/ /that is > about all I can think of. Any thing missed? I am leaning towards a shop > doing it anyone have this done in the past and the cost? > Thanks for listening. > Tom Jansen > Coppell , Tx. >

-- Jeff Ensing Ensing Remodeling 3327 hidden acres Drive Atlanta, Ga. 30340 678-549-8430


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.