Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2009, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 20 Jul 2009 19:58:43 -0500
Reply-To:     Jim Felder <jim.felder@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jim Felder <jim.felder@GMAIL.COM>
Subject:      Re: Inject grease into rear wheel bearings w/o disassembly?
Comments: To: Tom Hargrave <thargrav@hiwaay.net>
In-Reply-To:  <044401ca099a$fb160ba0$3400a8c0@tomrmkj2yanjy9>
Content-Type: text/plain; charset=ISO-8859-1

Oops just noticed that this is about WHEEL bearings not CV BEARINGS. Please forgive the oversight.

Jim

On Mon, Jul 20, 2009 at 7:34 PM, Tom Hargrave<thargrav@hiwaay.net> wrote: > Martin, > > The most important part of repacking wheel bearings is not replacing the > grease. The most important part is inspecting the bearings & races for wear > & damage and re-adjusting your wheel bearing pre-load. Just adding grease to > a wheel bearing accomplishes none of this. > > Thanks, > Tom Hargrave > Our Web Sites: > www.kegkits.com > http://www.kegkits.com/JABF/ > www.stir-plate.com > www.andyshotsauce.com > 256-656-1924 > > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@GERRY.VANAGON.COM] On Behalf Of > Poppie Jagersand > Sent: Monday, July 20, 2009 7:05 PM > To: vanagon@GERRY.VANAGON.COM > Subject: Inject grease into rear wheel bearings w/o disassembly? > > While under the Vanagon to pull the starter I noticed the rubber boot on the > passenger side CV joint is torn. No clunks from the CV's yet, so I was > planning just to order four Febi boot and grease kits from busdepot and > repack CV's. > > I was thinking that a rear wheel repacking might also be good, but I'm too > busy/(lazy) this summer to also disassemble rear stub axles. (There is no > sound or sign of the bearings being bad) > > Is there some other way to get grease on into the rear wheel bearings? With > an injection needle? > > Martin > > >      __________________________________________________________________ > The new Internet ExplorerR 8 - Faster, safer, easier.  Optimized for Yahoo! > Get it Now for Free! at http://downloads.yahoo.com/ca/internetexplorer/ >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.