Date: Mon, 27 Jul 2009 12:22:52 -0400
Reply-To: Jim Akiba <syncrolist@BOSTIG.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jim Akiba <syncrolist@BOSTIG.COM>
Subject: gov't sure fire way to destroy an engine Re: about oil additives
In-Reply-To: <ac1f198b0907270921j476bfa23v2cb83fb8bffcff00@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1
I wonder if any vanagons are going to be euthanized via this program.
Here is the official government procedure for the dealers to ensure
engines are destroyed when you go to trade in the vanagon for a kia
ha. It's disturbing in many ways. I thought this was particularly
relevant to vanagons owners because vanagon owners tend to use
recycled parts, including engines for upkeep and conversions.
Appendix B to Part 599 - Engine Disablement Procedures for the CARS Program
Engine Disablement Procedures for the CARS Program
THIS PROCEDURE IS NOT TO BE USED BY THE VEHICLE OWNER
Perform the following procedure to disable the vehicle engine.
Since the vehicle will not be drivable after this procedure is performed,
consider where the procedure will be performed and how the vehicle
will be moved after the procedure is complete.
1. Obtain solution of 40% sodium silicate/60% water. (The Sodium Silicate
(SiO2/Na2O) used in the solution must have a weight ratio of 3.0 or greater.)
2. Drain engine oil for environmentally appropriate disposal.
3. Install the oil drain plug.
4. Pour enough solution in the engine through the oil fill for the oil pump to
circulate the solution throughout the engine. Start by adding 2 quarts of the
solution, which should be sufficient in most cases.
CAUTION: Wear goggles and gloves. Appropriate protective clothing
should be worn to prevent silicate solution from coming into contact with the
skin.
5. Replace the oil fill cap.
6. Start the engine.
7. Run engine at approximately 2000 rpm (for safety reasons do not operate at
high rpm) until the engine stops. (Typically the engine will operate for 3 to 7
minutes. As the solution starts to affect engine operation, the operator will
have to apply more throttle to keep the engine at 2000 rpm.)
8. Allow the engine to cool for at least 1 hour.
9. With the battery at full charge or with auxiliary power to provide
the power of
a fully charged battery, attempt to start the engine.
10. If the engine will not operate at idle, the procedure is complete.
11. If the engine will operate at idle, repeat steps 6 through 10
until the engine
will no longer idle.
12. Attach a label to the engine that legibly states the following:
This engine is from a vehicle that is part of the Car Allowance Rebate
System (CARS). It has significant internal damage caused by operating
the engine with a sodium silicate solution (liquid glass) instead of oil.
| 
