Motive Power Bleeder...google it...must be around $60..Work good. Don Hanson On Wed, Aug 5, 2009 at 7:46 PM, Andy Morse <andysings@aol.com> wrote: > What is the size of the bleeding screws on an 86 syncro?? I need to replace > them all. I'm assuming almost any autopart store would have them. > > I've finally found some time to reassemble the dash on my 86 (if you > remember I was replacing my heater blower) The new blower unit is in the > housing and I mounted the housing. I've replaced all the tiny bulbs, > installed a new 12 volt outlet and replaced the radio antennae. > > I'm waiting to put the dash in until I bleed the brakes since I put a new > brake master cylinder in and to know I have strong brakes once again. My > hesitation is I'm a bit wary of the brake servo ( i should have tested it > before I took the dash out) Is there any way to test the servo in the state > my dash is in? > > Does anyone recommend a one person brake bleeder that I can operate by > hand? Under $60. I have 6 vehicles and it would be nice to have something > more user friendly than just a piece of plastic funnel that gets stuck in > the bleeder screw attached to a tube and bottle. > > Thank you, Andy > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.