Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2009, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 21 Aug 2009 21:09:04 -0400
Reply-To:     Jeff Lincoln <magikvw@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Jeff Lincoln <magikvw@GMAIL.COM>
Subject:      Re: '90 2.1: What are the chances that I just fried my engine?
              UPDATE
Content-Type: text/plain; charset=ISO-8859-1

OK, well this might get kind of long and there will most likely be several questions. I'll provide as much info as I can.

*The driver's side head gasket is most definitely shot *The large plastic water distribution piece blew an end out *The coolant line/pipe that enters the passenger side head at the rear (rear of the van) appears to be leaking coolant *Oil shows no sign of water in the oil but was very low (it wasn't low last I checked last week) *No leaking from the block *The van starts right up runs and sounds normal *No leaking from the passenger side head

The Plan:

1. Check compression 2. Remove heads have them checked - if warped replace with heads from parts bus. 2. Replace head gaskets 3. Replace gasket to the coolant line/pipe at the rear of pass head 4. Replace coolant distribution piece 5. Change oil

The Questions:

1. Do both head gaskets need to be replaced if the pass side isn't leaking? (seems the right thing to change both but someone has suggested otherwise)

2. If compression test proves poor (I suspect it wont) is it worth even proceeding with the repair?

3. Where did my oil go? Could it have been purged during over heating too? There is clearly oil in the engine bay.

4. The age old question - remove the engine to do the repair or do it in the bus?

5. I know I'm missing something, misguided, or not thinking of something because I lack the knowledge and experience with this type of repair. So set me straight :)

There you have it Sorry to present such a long post but this is very new ground for me. Now I guess I need to go look through Benny Boys website for a while.

Thank you all in advance for any words of wisdom advice and whatever else you can send my way. Good Grief.

-- Thanks,

Jeff '90 Carat (Grover) '86 (We call this one Parts) '78 Bus (Melissa) Patty's Bus


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.