Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2009, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 26 Aug 2009 19:02:48 -0400
Reply-To:     Mike S <mikes@FLATSURFACE.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mike S <mikes@FLATSURFACE.COM>
Subject:      Re: Engine to auto-tranny match and the Indy 500
Comments: To: rolftruck@AOL.COM
In-Reply-To:  <8CBF4B1E491E17D-1A60-6871@webmailalpo-m06.sysops.aol.com>
Content-Type: text/plain; charset="us-ascii"; format=flowed

At 06:15 PM 8/26/2009, Rolf Lockwood wrote... > Torque is defined as an engine's ability to do work, characterized > by the twisting motion off the end of the crankshaft.

No. Work is done by power over time, not force (torque). Try lifting a 1000 lb. weight. You can tug and tug, and you will be applying a lot of force. You might even "work up" a sweat, but unless you actually lift that 1000 lbs. off the ground, you haven't done any work.

> Horsepower is a purely calculated value that measures only the speed > at which the work is done. So the ONLY thing that gets you over the > crest of a hill is torque,

Nope. You need to study some physics. Force only does work when it actually moves something. Work over time is power.

>Torque is an absolutely 'tangible' value, horsepower a mere >calculation.

No. One HP is the amount of power it takes to raise 550 pounds 1 foot in 1 second. (foot-pounds, not to be confused with pounds-feet, which is a measure of torque) Power is the rate at which work is done. You're probably confused by the fact that one can convert torque to HP with the formula RPM x Torque x 5252 = HP. But you can just as easily start with HP: HP / 5252 / RPM = Torque.

When a car is put on a dynamometer, it is power which is measured (the amount of work needed to turn a weight or heat a liquid, and how long it takes to do so), and torque is calculated.

Moving a Vanagon up a 1000 foot hill is the same amount of work, whether you're going 10 or 60 MPH. But, to go 60 MPH, you need more power, which allow you to do the same amount of work in less time.

Here's a pretty good explanation. Don't feel discouraged, it confuses a lot of people: http://auto.howstuffworks.com/auto-parts/towing/towing-capacity/information/fpte.htm


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.