Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2009, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 7 Sep 2009 08:07:32 -0400
Reply-To:     Benny boy <huotb@VIDEOTRON.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Benny boy <huotb@VIDEOTRON.CA>
Subject:      Replace your ignition switch.

I was looking at my invoices because i was wondering where all my switches went, have replaced/ordered 13 this summer, 7 where for broken/stranded van, 4 where towed to my shop, 3 barely made it, the other where for engine conversion, the Subi is sensitive to unstable/low 12V as to "start signal and ignition +, on 1/3 of the conversion the engine won't start or will run rough on idle, when i see that i know i have a bad IGN switch.

It cost nothing.

And here is how to do it: http://www.benplace.com/dash.htm

Ben


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.