Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2009, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 7 Sep 2009 17:59:19 -0700
Reply-To:     aatransaxle <daryl@AATRANSAXLE.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         aatransaxle <daryl@AATRANSAXLE.COM>
Subject:      Re: Minimal vanagon support kit
Comments: To: mcneely4@COX.NET
Content-Type: text/plain; format=flowed; charset="utf-8"; reply-type=response

I put a Zetec engine in mine..Carry waaay less shtuff.... Now just a small tool bag and a serp belt and a gal of water... Daryl of AA Transaxle (425) 788-4070 aatransaxle.com 86 Syncro Westy Zetec in the trunk ----- Original Message ----- From: "Dave Mcneely" <mcneely4@COX.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Monday, September 07, 2009 11:29 AM Subject: Re: Minimal vanagon support kit

> Wow, look at all the stuff some of you guys find necessary to carry to > make sure your vanagons get you wherever and back! > > GoWesty has another idea, of course. Spend 40 or 50k with them to make > a vanagon equivalent to new (or better, they claim). > > Not difficult vehicles? Reliable? > > Sure, they're old. And they're difficult. But, oh well. So am I. > > Dave Mc > > Oh, my van is a '91 Vanagon GL Campmobile. > > Oh, I guess what I need is a list of all the do-overs that I need to do > to make sure my vanagon mechanical systems are all sound. Let's see -- > > I've got a nearly new rebuilt engine (22k miles. chassis has 145k > miles). > Transmission drained and refilled (manual transmission). > I've redone all the ignition parts -- plugs, points, rotor, cap, wires. > New air filter. > New fuel injection lines (they were part of the engine rebuild). New > fuel filter and new fuel lines from tank to filter and filter on. New > fuel pump. > New AFM. > five New heavy duty tires, Kumho 857s: 195R14C. More than meet specs > for weight capacity (load level D, spec is for C), 8 ply rating. tires > come with lifetime rotate and balance, including spare. I'm a nut about > keeping this up on all my vehicles. Van drives well with these tires. > Run these at 53 psi rear, 43 psi front per VW spec. Tire spec allows up > to 65 psi, which I will go with if I think I may be carrying the maximum > weight. > Brakes inspected, fluid flushed and refilled, and good to go. > Alignment (but, was unaware that one needs (according to some of you > guys) to load the vehicle before doing the alignment, do the alignment, > drive it, do the alignment again). Wow. Of course, that's not > DIFFICULT. Fortunately, mine drives with the steering wheel dead on > center, and will track absolutely on a straight, level road, whether > loaded or not. Good enough? It is considered so on most vehicles. > New cv joints. New ball joints, upper and lower. Shocks check as > excellent (fairly new). No steering play, no vibration or bounce. > Wheel bearings good, newly greased. > New radiator, new radiator temperature switch. Complete flush. New > phosphate free coolant with distilled water (the expensive VW stuff, > probably not necessary, but ............ ). New temperature sender. > Fan motor hot post repaired where broken during radiator replacement. > New coolant distribution manifold (the one that reportedly fails > catastrophically. Mine broke during another repair, so not so > catastrophic). > Plan to redo all coolant hoses, and plastic pipe ends, pending new > funds. > New water pump (twice, due to failure of first new one). New > thermostat. > New oil pump (not needed, mistake). > New motor mounts. > New drive belts. > Oil pressure monitoring system redone, including new sensors, new wire > to gauge and instrument cluster. Idiot light and gauge both working > properly (gauge reads about 5 lbs lower than actual according to > independent mechanical check). BTW, pressure senders set up on a single > tube (with a T) from the engine case for both high and low pressure, > eliminating the difficult to access high pressure sender location. > Senders and tube secured with a bracket to engine case to minimize > vibration. > Currently running Valvoline 50W due to extreme summer temps in some > areas I've been driving. Will change to multi-vis (15W-50 if I can get > it, otherwise 20W-50 Castrol) next month or so with cooler weather. If > I decide to drive during winter, and can't get the 15W-50, I may go with > 10W-40, or with 30W. > Clutch engages and disengages well. No idea when it was redone, if > ever. Evidently not with engine replacement, as paperwork does not > reflect it. > New wiper blades and rear hatch struts. > Very slight leak from oil cooler, will replace o-ring at next oil change > (not leaking enough to spot under the vehicle, and not enough to require > adding oil between changes). > I carry spare fuses and bulbs, and spare drive belts. Guess I'll get > some of that "Rescue Tape." > > I keep my AAA card and cell phone handy. > > What have I missed? > > Dave Mc


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.