Date: Wed, 9 Sep 2009 09:20:31 -0400
Reply-To: mcneely4@COX.NET
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Dave Mcneely <mcneely4@COX.NET>
Subject: Re: Oil Pressure Sensor/Pump?
Content-Type: text/plain; charset=UTF-8; format=flowed; delsp=no
Sunshine, I would look to other causes before the oil pump. Numbers of
others have now told me that they rarely fail. More likely, if you
indeed do have low oil pressure (try to find every reason that you might
be getting the signal despite adequate oil pressure first), its unlikely
to be due to the pump -- but rather something more serious, internal to
the engine. Almost as good a temporary patch on that as a new pump is
heavier oil, at least while the weather is warm. Single weight oil
holds its viscosity better than does multi-vis, too. If your vehicle is
running hotter than it should, multi-vis oil may be thinning too much as
the engine reaches the higher temperature.
Dave Mc (no expert, but have recently gone through some of this oil
pressure business. Mine wa a combination of coolant system problems and
the wrong oil, plus a monitoring system that was out of kilter)
On Tue, Sep 8, 2009 at 8:32 PM , Sunshine wrote:
> guys I just checked and after cleaning the rear oil pressure sensor
> and
> refitting the connection, I started her up to back her to where there
> was more light and I noticed the LED IS flashing!!
> So does this mean I need a new sensor or perhaps even a new oil pump?
>
> Peace, Love & VW Grease,
> Sunshine
> ~~~~~~~~~~~~~~~~~~~~~~
> '89 Vanagon GL - Wolfsburg Weekender Edition ("Stella Blue") *Daily
> Driver*
> '87 Vanagon GL ("Parts Van")
> '77 Westfalia Bus ("Sunshine Daydream")
> '74 Transporter Bus ("Buddy")
> On Sep 8, 2009, at 6:50 PM, Karl wrote:
>
>> The coolant level sensor should definitely have an o-ring on it. The
>> sensor will crack easily if overtightened, I usually just smear a
>> light
>> coat of silicone grease on em and snug down by hand with a socket, no
>> ratchet attached. (or if it's an old one I'll put a small bead of
>> black
>> RTV on the oring)
>>
>> Check your oil if the buzzer goes off in turns and bumps, maybe it's
>> really low? :-)
>>
>> karl
>>
>> Sunshine wrote:
>>> The buzzer, now that I think about it, only goes off when I round a
>>> corner or hit a bump. I'm thinking I might have pinched it while
>>> replacing one plastic white coolant pipes because it blew off at
>>> where
>>> it connects w/ the rubber radiator hose....the plastic end popped
>>> off,
>>> therefore shoving the metal piece into the rubber part of the hose,
>>> see
>>> this article for more reference:
>>>
>>> ANYWAY I think when I lowered the spare tire to get at the hose to
>>> take
>>> the old one out and install the donor one from my parts vanagon, I
>>> might
>>> have pinched the wiring and therefore grounding it out when I hit a
>>> bump
>>> or turn and causing the buzzer to sound.
>>>
>>> NOW, I tightened the coolant level sensor down a bit and it still
>>> seems
>>> to be seeping coolant, although not as bad, anyway I did order a new
>>> coolant level sensor but it didn't call for an o-ring to seal it and
>>> the
>>> old one doesn't have one, so I'm not sure if I should just maybe
>>> clamp
>>> the coolant hose and take out the expansion tank again to retighten
>>> down
>>> the coolant level sensor?
>>
>>
|